Mitsubishi Electric PAR-21MAA Livret D'instructions page 8

<Selecting the Mode>
I With the unit running, press the Mode button 2 as many times as necessary.
• Each press switches operation to the next mode, in the sequence shown below.
The currently selected mode is shown at 2.
→ COOL → DRY → FAN → AUTO → HEAT → Ventilate
*1 *1,*3,*4
Note:
*1 Availability of this mode depends on the type of unit connected.
*2 Appears only on Mr. Slim units with installed ventilation functionality.
*3 Does not appear if Auto Mode has been disabled at the Function Selection of remote
controller. For information about how to set this function, refer to section 6, item [4]–
2 (2).
*4 HEAT and COOL do not appear during AUTO mode if Auto mode display has been
disabled at the Function Selection of remote controller. For information about how to
set this function, refer to section 6, item [4]–4 (3).
<To Change the Room Temperature Setting...>
I To lower the temperature: Press the
I To raise the temperature: Press the
• Each press changes the setting by 1 °C. The current setting is displayed at 3.
• The available ranges are as follows. *1, *2
COOL or DRY
HEAT mode
mode
19 - 30 °C 17 - 28 °C
(67 - 87 °F) *3 (63 - 83 °F) *3
Note:
*1 Available ranges vary according to the type of unit connected (Mr. Slim, CITY MULTI,
etc.).
*2 If temperature range limits have been set at Function Selection of remote controller,
the available ranges will be narrower than shown above. If you attempt to set a value
outside of the restricted range, the display will show a message indicating that the
range is currently restricted.
For information about how to set and clear these range limits, refer to section 6, item
[4]–2 (3).
*3 If Function Selection of remote controller are set to display the temperature in
Fahrenheit. For information about how to select °C or °F , refer to section 6, item [4]–
4 (1).
*1 *1,*2
Set Temperature button 3.
Set Temperature button 3.
AUTO mode FAN
19 - 28 °C
Cannot be set.
(67 - 83 °F) *3
<Room Temperature Display>
During operation, the intake temperature is shown at 4.
Note:
G To display range is 8 °C to 39 °C. If the temperature is below 8 °C or above 39 °C,
the corresponding value (8 °C or 39 °C) will blink on the display.
G If you are using the remote controller to drive multiple indoor units, the display will
show the temperature at the master unit.
G You can select which temperature sensor to use to detect the temperature: either the
sensor at the indoor unit ("At Unit"), or else the sensor at the remote controller ("At
Remote"). The default setting is "At Unit".
To change the location of the sensor at the indoor unit:
• CITY MULTI models: Consult your dealer.
• Mr. Slim models: Refer to the installation instructions.
G If room temperature display is disabled in Function Selection of remote controller, the
room temperature will not appear. For information about how to enable or disable this
feature, refer to section 6, item [4]–4 (2).
G If Fahrenheit display is selected at Function Selection of remote controller, the display
will show the °F mark. For information about how to select °C or °F, refer to section
6, item [4]–4 (1).
– 8 –