Mitsubishi Electric PAR-21MAA Livret D'instructions page 17

(4) Locking the Remote Controller Buttons (Operation function limit
controller)
I If you wish, you can lock the remote controller buttons. You can use the Function
Selection of remote controller to select which type of lock to use. (For information
about selecting the lock type, see section 6, item [4]–2 (1)).
Specifically, you can use either of the following two lock types.
1 Lock All Buttons: Locks all of the buttons on the remote controller.
2 Lock All Except ON/OFF: Locks all buttons other than the ON/OFF button.
Note:
The "Locked" indicator appears on the screen to indicate that buttons are currently
locked.
TIME SUN
˚C
TEMP.
MENU ON/OFF
BACK MONITOR/SET DAY
PAR-21MAA CLOCK
1
Lock Indicator
FUNCTION
˚C
ON/OFF
1
FILTER
4
CHECK TEST
OPERATION
CLEAR
<How to Lock the Buttons>
1. While holding down the Filter button 4, press and hold down the ON/OFF button 1
for 2 seconds. The "Locked" indication appears on the screen (at 1), indicating that
the lock is now engaged.
* If locking has been disabled in Function Selection of remote controller, the screen
will display the "Not Available" message when you press the buttons as described
above.
˚C
• If you press a locked button, the "Locked" indication (at 1) will blink on the display.
˚C
<How to Unlock the Buttons>
1. While holding down the Filter button 4, press and hold down the ON/OFF button 1
for 2 seconds—so that the "Locked" indication disappears from the screen (at 1).
˚C
– 17 –
1
FUNCTION
˚C
1
FUNCTION
˚C
1
˚C