Publicité
Les langues disponibles
Les langues disponibles
To select the subwoofer cutoff frequency
– CUTOFF F
When a subwoofer is connected to this unit,
select an appropriate cutoff frequency level for
your subwoofer.
When shipped from the factory, the subwoofer
cutoff frequency is set to "FREQ MID."
• FREQ LOW: Frequencies higher than 50 Hz
are cut off to the subwoofer.
• FREQ MID: Frequencies higher than 80 Hz
are cut off to the subwoofer.
• FREQ HIGH: Frequencies higher than 120 Hz
are cut off to the subwoofer.
To adjust the line input level
Adjust the line input level properly when an
external component is connected to the LINE IN
plugs.
When shipped from the factory, the line input
level is set at level 00.
If the input level of the connected component is
not high enough, increase the input level
properly. Without adjusting the line input level,
you may be surprised at a loud sound when you
change the source from the external component
to another source.
To adjust the auxiliary input level
– AUX ADJ
Adjust the auxiliary input level properly when an
external component is connected to the Auxiliary
input jack.
When shipped from the factory, the auxiliary input
level is set at level 00.
If the input level of the connected component is
not high enough, increase the input level
properly. Without adjusting the line input level,
you may be surprised at a loud sound when you
change the source from the external component
to another source.
To select the target component to operate
through this receiver
You can operate either JVC's DVD player or VCR
through this receiver, by using the number
buttons on the control panel.
When shipped from the factory, these number
buttons are set to be used for the DVD
operations.
To use these number buttons on the control panel
for DVD or VCR operations, see page 37.
– LINE ADJ
– KEY SELECT
To change the FM tuner selectivity
– IF FILTER
In some areas, adjacent stations may interfere
with each other. If this interference occurs, noise
may be heard. This unit has been preset to
automatically reduce this interference noise
("AUTO") when shipped from the factory.
• AUTO:
When this type of interference occurs,
this unit automatically increases the
tuner selectivity so that interference
noise will be reduced. (But the stereo
effect will also be lost.)
• WIDE:
Subject to the interference from
adjacent stations, but sound quality
will not be degraded and the stereo
effect will not be lost.
To turn the demo mode on or off
You can turn the demo mode on or off. When
shipped from the factory, "DEMO ON" is selected.
• DEMO ON:
Turns the demo mode on. The
demonstration will start
automatically if no sound comes in
for 3 minutes.
• DEMO OFF: Turns the demo mode off.
Note:
If the unit has been reset (and the power is on),
demonstration will start if no sound comes in for
about 10 seconds.
To turn the tag display on or off
An MP3 file can contain file information called
"ID3 Tag" where its album name, performer, track
title, etc. are recorded.
There are two versions–ID3v1 (ID3 Tag version
1) and ID3v2 (ID3 Tag version 2). This unit is
compatible only with ID3v1.
When shipped from the factory, "TAG ON" is
selected.
• TAG ON:
Turns on the ID3 tag display
while playing MP3 files.
* If an MP3 file does not have
ID3 tags, directory name and
file name appear.
Note:
If you change the setting from "TAG
OFF" to "TAG ON" while playing
an MP3 file, the tag display will be
activated when the next file stars
playing.
• TAG OFF:
Turns off the ID3 tag display
while playing MP3 files. (Only the
directory name and file name can
be shown.)
– DEMO MODE
– TAG DISP
33
Publicité
