Gima HTD8816C Mode D'emploi page 25

25
As below step:
1. In the boot or shutdown state, short press the MEMO button to view the history of
measured values.
2. An empty memory cell shows "---℃" or "---℉".
3. Temperature readings can be stored in memory. Up to 50 temperature readings can
be stored into the memory cells and automatically overwrite historical data.
4. In boot mode, press the MEMO button until the LCD display "CLR", which means
that all stored data is cleared completely.
Parameter settings
This product can be set according to the subjects of different colors and different
environments data to meet the different characteristics of populations or individuals.
As below step:
1. Unit Set-F1
Under the boot mode, long press the MODE button to enter F1, press the "MODE"
or "MEMO"button to switch Celsius and Fahrenheit temperature units, press the
On/Scan button to confirm the unit settings (factory default is Celsius).
2. Fever alert set-F2
Under F1 state ,press On/Scan button to enter the F2, press the "MODE" button to
plus 0.1℃, press the "MEMO" button decrease 0.1 ℃, long press to accelerate the
speed of temperature regulation, and finally press the On/Scan button to save. (The
factory default is 38.1℃).
3. Prompt sound settings-F3
Under F2 state, press On/Scan button to enter F3, press MODE button or MEMO
button to set voice switch, and press the On/Scan button to confirm the settings.
(The factory default is the voice Prompt to open).
4. Exit setting mode
In the F3 mode, press the On/Scan button will automatically turn off the screen, exit
setting.
Prompt sound settings ON/OFF function
Under the boot mode .Short press power on/off button ,at the same time press the
MODE button to take on or take off the Prompt sound function.
Restore to factory setting function
Under the boot mode .Short press power on/off button ,at the same time press the
MEMO button. Until LCD display "rst". Two seconds later ,former F1-F3 parameter
back to factory setting.
ENGLISH