Publicité
Les langues disponibles
Les langues disponibles
• You cannot use the thermometer in place where the sun is strong.
• If for some reason the low forehead temperature measurement can try to align
behind the ears. See figure 3.
General Setup and Use
Start measuring
1. Turn on the thermometer by pressing the On/Scan button. The thermometer will
perform self-test with all segments displayed for 2 seconds.
2. Align staff forehead to keep the distance, and then press the On/Scan button to
start the measurement, read the data.
Note: 1) After full display over, you will hear a rattle or "beep beep beep" three times,
which means that the measurements have been completed, while the target value of
the measured temperature is displayed on the LCD, while backlit display according
to the appropriate setting among the three colors red, green, yellow one of. And the
Green means ready for next measurement. When 37.4℃-38.0℃, it's yellow ,means
slight fever warning. Please pay attention to body temperature. When the body tem-
perature is above 38.1℃, it's red, means high fever. Please take action to cool down
or go for a doctor.
2) To ensure the accuracy of the measurement, wait at least 30 seconds after 5 con-
secutive measurements.
Mode conversion
When the device is running, pressing the MODE button to cycle conversion between
"body" mode and "surface" mode.
"body" mode is used for measuring human body temperature, the "surface " mode
is used to measure the surface temperature. (The factory default is "body" mode).
Recalling and Erasing Memory Data
The last temperature taken before the thermometer powers off is stored in memory,
up to 50.
ENGLISH
Figure 3- Align behind the ears
to measurement
24
Publicité
