Auto Mode; Sound Mode; Dmx Mode - Evolite Evo Wash 740z Strip Mode D'emploi

 MENU
Function
Dmx Address
Mode
Channel Mode
Auto Run
Music Control
Reset Default
Option
Signal Set
Pan / Tilt
UI SET
Information Temperature
Software Version
Manual
Control Reset
Channel
Advanced
Calibration
(Access Code
088)
o Auto Mode
Press the MENU key then ENTER, then use the DOWN key to reach the AUTO RUN menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.

Sound Mode :

Press the MENU key then ENTER, then use the DOWN key to reach the Music Control menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
o DMX Mode
Each device can be individually controlled using a standard DMX-512 controller.
You must "address" each device through the "A001" menu. The filled-in address is then the base
address, address from which the device will respond.
If two devices are addressed to the same DMX address; they will then behave identically, responding
to the same DMX channels.
Evo Wash 740z Strip User's Manual Ver. 1.00
MENU
MENU
A001~AXXX
Ch31
Ch25
Ch59
Internal Program1~9
State:Master/Alone
Auto Run (On/Off)
Internal Program1~9
State:Master/Alone
Music Run (On/Off)
Yes/No
Cable DMX
WDMX&Out Cab
Reverse Pan (On/Off)
Reverse Tilt (On/Off)
Select Pan 630°/540°/360°
Select Tilt 270°/180°/90°
Mic SEN 0~99%
OFF Signal Mode (On/Off)
XXX°C/°F
V1.0~V9.9
Total Reset
Pan/Tilt Reset
Zoom Reset
PAN=XXX......
PAN=XXX......
Description
Description
DMX address setting
31 Channel Mode
25 Channel Mode
59 Channel Mode
Internal Program
Auto Run State
Open Auto Run
Internal Program
Sound Control State
Open Sound Control
Reset Default
Cable DMX
WDMX&Out Cab
Reverse Pan
Reverse Tilt
Pan Degree,default is 540°
Tilt Degree,default is 270°
Sensitivity Setting
OFF at original status and
ON at reset status when no
DMX signal
Current Temperature
Software Version
Total Reset
Pan/Tilt Reset
Zoom Reset
Manual Channel Control
Calibration(Code:088)
26
Page