Sommaire des Matières pour Evolite Evo Wash 740z Strip
Page 1
7x40W wash moving head User manual / Mode d’emploi Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Page 2
Ne pas utilisez le projecteur avec une température ambiante supérieure de 40°C. ATTENTION ! Risque d’incendie. Il est important de garder éloigner tous matériaux combustibles et inflammables de l’appareil en fonctionnement. Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Page 3
Cet appareil présente des risques importants de blessures. Il est important de manipuler et d’utiliser cet appareil de façon professionnelle, par un utilisateur qualifié. Cet appareil evolite doit être installé avec des crochets solides et de dimension adéquate au poids supporté. L’appareil doit être vissé aux crochets et serré convenablement afin d’éviter toute chute due aux vibrations produites par la machine en fonctionnement.
Installation o Accroche Ce projecteur asservi evolite doit être installé avec des crochets solides et de dimension adéquate au poids supporté. L’appareil doit être vissé aux crochets et serré convenablement afin d’éviter toute chute due aux vibrations produites par la machine en fonctionnement.
Lorsque vous branchez le câble d’alimentation secteur et activez l’interrupteur de mise sous tension à l’arrière de l’appareil, celui-ci démarre et affiche un message d’accueil sur l’écran en face avant : Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Accédez directement au menu en appuyant sur la touche Menu puis déplacez-vous dans les menus grâce aux touches UP & DOWN. Appuyez sur la touche ENTER pour valider vos choix et valeurs. Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
La LED clignote vert lentement : LA connexion avec le transmetteur est établie, mais il n’y a pas de signal DMX. La LED est fixe vert : La connexion et le signal DMX sont bien opérants. Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Page 13
Gradateur de premier plan Variateur de premier plan 0 - 100%. 000..255 Couleur de fond des motifs Pas de fonction 0..0 rouge 1..13 14..27 vert Bleu 28..41 blanc 42..55 Rouge + blanc 56..69 Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Caractéristiques techniques Modèle Evo Wash 740z Strip Voltage 110V- 250V / 50-60Hz Consommation: 350W LEDs 7 x 40 W + 90x 5050 Poids brut 12 kg Dimensions du carton 430x320x490 mm Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Page 19
The fixture becomes hot during use and remains hot 10 min after use. Do not touch the unit. WARNING ! Fire Hazard! Keep flammable materials away from the fixture. Do not operate the fixture with ambient temperature over 40°C. Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Page 20
DANGER ! Safety Hazard. Risk of injury. This evolite unit must be installed by professional people. If suspended, make sure the structure and the hardware used for this suspension is secured. This Hardware must support at least 10 times the weight of the device suspended.
- Power consumption: 350W max - Dimensions of the device: 380 x 200 x 400 mm - Carton dimensions: 430 x 320 x 490 mm - Gross weight: 12 kg - Net weight: 9.5 kg Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
If you lack these qualifications, do not attempt the installation yourself. Improper installation can result in bodily injury. Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Page 23
Clamp Mounting: Evo Wash 740z strip provides a unique mounting bracket assembly that integrates the bottom of the base, and the safety cable rigging point in one unit (see the illustration below). When mounting this fixture to truss be sure to secure an appropriately rated clamp to the included omega bracket using a M10 screw fitted through the center hole of the “Hanging Kit”.
DOWN Access the menu directly by pressing the Menu key and move through the menus with the UP & DOWN keys. Press the ENTER key to confirm your choices and values. Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
You must "address" each device through the "A001" menu. The filled-in address is then the base address, address from which the device will respond. If two devices are addressed to the same DMX address; they will then behave identically, responding to the same DMX channels. Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
192..255 shutter open 0..255 0-100% Red dimmer from dark to bright Green 0..255 0-100% Green dimmer from dark to bright Blue 0..255 0-100% Blue dimmer from dark to bright White Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Page 30
Blue in pixel 6 0..255 Blue in pixel 6 saturation control(0-100%) White in pixel 6 0..255 White in pixel 6 saturation control(0-100%) Red in Pixel 7 0..255 White in pixel 7 saturation control (0-100%) Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Page 31
Pix Ganged Form Macro Total Number 0..255 Total Number Pix Ganged Form Macro The Serial Number 0..255 The Serial Number Special function 0..19 No function 20..29 No function 30..39 No function 40..79 No function Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Check the LED for the response of the master/ slave mode signal. No response to the sound Make sure the fixture does not receive DMX signal. Check microphone to see if it is good by tapping the microphone. Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...
Package Dimensions 430x320x490 mm www.evolite-pro.com Importé par / Imported by EVOLITE – MSC 7 avenue du 1er Mai 91120 Palaiseau / FRANCE infos@msc-distribution.com Tel : +33 1 69 34 80 62 Evo Wash 740z Strip User’s Manual Ver. 1.00 Page...