Auto Mode; Dmx Mode - Evolite Evo Wash 730z Pix Mode D'emploi

Select Tilt
Mic
sensitivity
OFF
Signal
Mode
MANU Reset
(Manual)
Channel
ADV
Calibration
Advanced
Access
Code 088)
o Auto Mode
Press the MENU key then ENTER, then use the DOWN key to reach the AUTO RUN menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
Sound Mode :
Press the MENU key then ENTER, then use the DOWN key to reach the Music Control menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
o DMX Mode
Each device can be individually controlled using a standard DMX-512 controller.
You must "address" each device through the "A001" menu. The filled-in address is then the base
address, address from which the device will respond.
If two devices are addressed to the same DMX address; they will then behave identically, responding
to the same DMX channels.
Wired DMX mode :
Press the MENU key and then DOWN to access the next menu. Then press ENTER then DOWN to reach
the Signal Set menu. Press ENTER and then check the DMX Cable box. Confirm this choice by pressing
ENTER.
Press the MENU key and then UP to go to the first menu. Press ENTER to select the Dmx Address menu.
Use the UP & DOWN keys to select the DMX address of the device. Press ENTER to confirm your choice.
Finally, press MENU 2 times to return to the main menu. The unit is in DMX mode, and if no DMX signal
is present, the display flashes. Then connect a DMX cable as input.
DMX mode selection via W-DMX (wireless):
Evo Wash 730z Pix User's Manual Ver. 1.00
All manuals and user guides at all-guides.com
270°/90°/180°
Mic SEN 0~99%
OFF Signal Mode (On/Off)
Total Reset
Scan Reset
Zoom Reset
PAN=XXX......
PAN=XXX......
is 540°
Tilt Degree,default
is 270°
MIC Sensitivity
Setting
OFF at original
status and
ON at reset status
when no
DMX signal
Total Reset
Scan Reset
Zoom Reset
Channel Control
Calibration
Page
22