Set Password - Uline H-2812 Mode D'emploi

DAYLIGHT SAVINGS TIME CONTINUED
END DATE
CHANGE THE YEAR
1. Press SELECT until the q is above the "DST END" mark.
2. The flashing digit indicates "Year."
3. In this example, the "Year" is not being changed.
Refer to DST on page 12.
4. Press SET. (See Figure 43)
Year
Figure 43
MO
SELECT
5. The flashing changes from "Year" to "Month."
(See Figure 44)
Figure 44
SELECT
CHANGE THE MONTH
1. In this example, press CHANGE until the month is "11"
(November). Refer to DST on page 12.
2. Press SET.
3. The flashing changes from "Month" to "Date."
(See Figure 45)
Figure 45
SELECT
PAGE 14 OF 57
OPERATION CONTINUED
Date
Month
TU WE TH FR SA SU
DST
END
CHANGE SET
DST
END
CHANGE SET
DST
END
CHANGE SET
CHANGE THE DATE
1. In this example, press CHANGE until the date is "02."
Refer to DST on page 12.
2. Press SET.
3. The "Ending Date" of the display changes from
flashing to steady and the p mark is displayed
under "SU." (See Figure 46)
Figure 46
SELECT

SET PASSWORD

Once the password is set, you must enter it before
changing any settings. Refer to "Enter Password" on
page 15.
You may choose any 4-digit number from
0001 to 9998. Numbers "0000" and "9999"
are not valid passwords.
All settings must be reset if you forget the password.
Refer to "Reset Factory Default Settings" on page 15.
Example: Set the Password to "1234."
1. Press SELECT until the q is above the "PASSWORD"
mark.
2. The first 2 digits flash. (See Figure 47)
Figure 47
SU
DST
END
CHANGE SET
0721 IH-2812