Uline H-4571 Mode D'emploi

WOOD FRAME RADIO CONTROLLED WALL CLOCK
H-4571
SET UP
1. Insert a new "AA" battery (not included) into the back
of the clock and slide button to your time zone.
NOTE: If no time zone is selected, the clock will
default to Pacific Time.
2. For best results place clock within 6-10' of a window.
3. Once the battery is installed, the second hand will
advance 8 seconds (2 seconds per step, times 4
steps).
4. Within 5 minutes, the clock will either receive the
signal and set itself to the exact time or it will fast
forward the hands to the 4, 8 or 12 o'clock position
and continue to search for a signal.
5. In most cases, the signal will be found overnight.
6. If the hour hand is incorrect after the clock sets itself,
reset the button to your time zone.
DAYLIGHT SAVINGS TIME (DST)
If you live in an area that does not recognize DST
(Arizona or Indiana), slide the DST button to the "OFF"
position to deactivate the DST program. To reactivate,
slide the DST button to the "ON" position. (See Figure 1)
Figure 1
Time Zone
Button
NOTE: If the DST button is activated, the clock
will automatically advance one hour in the
Spring and 11 hours in the Fall.
PAGE 1 OF 3
1-800-295-5510
INSTRUCTIONS
SET WAVE
RESET
IECLR6 +
+
DST
Button
P M C E ON DST OFF
uline.com
MANUAL TIME SETTING
On rare occasions, the clock may not connect to the
radio signal within 24 hours because of the strength of
the signal or geographic location.
The clock can be set manually and used as a regular
quartz wall clock until it finds the radio signal.
For time zones outside of PT, MT, CT or ET, you must
manually set the time.
To set manually, press and hold the "SET" button on
the back of the clock and use the "WAVE" button to
advance until you reach the desired time. The clock will
continue to search for the radio signal. (See Figure 2)
Figure 2
Set
Button
TROUBLESHOOTING
If the clock is not picking up a signal:
1. Take the clock down, remove the battery and
replace with a new one.
2. Put the clock in an upright position in a new location
(by a window is suggested). Avoid putting the clock
near electrical items such as TVs and computers.
Select the appropriate time zone on the back of
the clock.
3. Put the clock down and leave it alone for 24 hours.
It should receive the signal overnight.
4. If the hour hand is incorrect after the clock sets itself,
slide button to your time zone.
Para Español, vea página 2.
Pour le français, consulter la page 3.
12
11 1
10
LA CROSSE
TECHNOLOGY
9
8
7 5
RADIO CONTROLLED
6
Wave
Button
SET WAVE
RESET
IECLR6 +
+
P M C E ON DST OFF
0621 IH-4571
2
3
4