Leading Zero; Preset Comments - Uline H-2812 Mode D'emploi

HOUR/MINUTE CONTINUED
5. The flashing digit indicates from "Hour" to "Minute."
(See Figure 22)
Figure 22
6. In this example, press CHANGE until the option is "2"
(1/100 Min.). Refer to Type of Minute Options below.
7. Press SET. (See Figure 23)
Figure 23
TYPE OF MINUTE OPTIONS
OPTION TYPE OF MINUTE
1 1/60 Min
2 1/100 Min
3 1/20 Min (=5/100 Min)
4 1/10 Min

LEADING ZERO

CHANGE LEADING ZERO
Example: Set the Leading Zero to "ZERO Disabled."
1. Press SELECT until the
(See Figure 24)
Figure 24
PAGE 10 OF 57
OPERATION CONTINUED
PRINT EXAMPLE
JAN 31 2008 10:10
JAN 31 2008 10.17
JAN 31 2008 10.15
JAN 31 2008 10.1
is under the "LEADING ZERO" mark.
p
2. The flashing digit indicates "Leading Zero Options."
3. In this example, press CHANGE until the option is "1"
(Leading Zero Option disabled). Refer to Leading
Zero Options below.
4. Press SET. (See Figure 25)
Figure 25
LEADING ZERO OPTIONS
OPTION LEADING ZERO
1 Zero Disabled
2 Zero Enabled

PRESET COMMENTS

Prior to enabling Preset Comments, refer to
Print Order Options on page 9 to ensure that
you have set up the print order options to
allow Preset Comments. (Options 12 through
18 allow Preset Comments.)
Example: Change the comment to "SENT."
1. Press SELECT until the
2. The flashing digit indicates "Comment Options."
(See Figure 26)
Figure 26
CHANGE COMMENT OPTIONS
1. In this example, press CHANGE until the option is "2"
(SENT). Refer to Preset Comment Options on page 11.
2. Press SET. (See Figure 27)
Figure 27
SELECT
PRINT EXAMPLE
JAN 1 PM 3:00
JAN 01 PM 03:00
is under the "COMMENT" mark.
p
COMMENT
CHANGE SET
0721 IH-2812