Publicité
Les langues disponibles
Les langues disponibles
The mounting and tensioning of the new
saw chain is described in the "Assembly"
section.
Servicing the blade bar
The blade bar has to be reversed every
8-10 operational hours in order to ensure
even wear (see the "Initial start-up" sec-
tion).
1. Switch off the device and unplug the
mains plug.
2. Remove the sprocket cover (12), the
saw chain (19) and the blade bar (18).
3. Check the blade bar (18) for wear. Re-
move burrs and straighten the guide
surfaces with a flat file.
4. Clean the oil outlet (
fault-free, automatic oiling of the saw
chain during operation
5. Mount the blade bar, saw chain and
sprocket cover and retighten the saw
chain (see the "Assembly" section).
When in an optimal condition, the
oil passages will automatically
spray the saw chain with a little oil
a few seconds after starting the
saw.
24) to ensure
GB
137
Publicité
