Husqvarna K 770 VAC Manuel D'utilisation page 59

CAUTION:
To examine the air filter
CAUTION:
remove the air filter. Particles that fall into
the carburetor inlet can cause damage.
Examine the air filter if the engine power decreases.
1. Loosen the 3 screws on the air filter cover.
2. Remove the air filter cover.
3. Examine the air filter. If it is necessary, replace the
To replace the air filter on page
air filter. Refer to
59 .
4. Replace the air filter cover.
5. Tighten the 3 screws.
To replace the air filter
CAUTION:
with compressed air. The air filter is made of
paper and is easily damaged.
Troubleshooting schedule
WARNING:
is off and the stop switch is in the
705 - 003 - 22.04.2022
Do not clean the fuel filter.
Be careful when you
Do not clean the air filter
Troubleshooting
Make sure that the engine
CAUTION:
spread out during filter change. Wear
approved respiratory protection. Dispose
filters correctly.
Note:
Replace the service filter only when it is
damaged.
Note:
The air filter must not be cleaned or blown clean
with compressed air. This will damage the filter.
1. Loosen the 3 screws on the air filter cover.
2. Remove the air filter cover.
3. Loosen the 2 screws on the air filter pulley and
remove it.
4. Remove the air filter.
5. Install the new air filter.
6. Replace the air filter pulley.
7. Tighten the 2 screws.
8. Replace the air filter cover.
9. Tighten the 3 screws.
STOP position before maintenance and
troubleshooting, unless the instructions tell
you differently.
Unhealty dust can be
59