Husqvarna K 770 VAC Manuel D'utilisation page 53

To start the product with a warm engine
WARNING:
blade can rotate freely. It starts to rotate
when the engine starts.
1. Make sure that the STOP switch is in the left
position.
2. Pull the choke control fully and get the start throttle
position.
3. Push the decompression valve to decrease the
pressure in the cylinder. The decompression valve
goes back to its initial position when the product
starts.
705 - 003 - 22.04.2022
Make sure that the cutting
4. Push the choke control to disable the choke. The
start throttle stays in position.
5. Hold the front handle with your left hand.
6. Put your right foot on the lower section of the rear
handle to push the product against the ground.
WARNING:
rope around your hand.
7. Pull the starter rope slowly until you feel a resistance
as the starter pawls engage. Then pull continuously
and quickly.
CAUTION:
rope fully and do not let go of the starter
rope handle when the starter rope is
extended. This can cause damage to the
product.
8. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.
Do not wind the starter
Do not pull the starter
53