Kärcher NT 14/1 Eco Mode D'emploi page 15

Suction turbine does not start again
after the container has been
emptied
Turn off the appliance and wait for 5 sec-
onds, turn it on again after 5 seconds.
Clean the electrodes as well as the space
between the electrodes with a brush.
Suction capacity decreases
Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
Replace the paper or fleece filter bag.
Ensure the filter cover properly locks
into place.
Replace the flat pleated filter.
Clean the exhaust filters under running
water and let them dry off.
Dust comes out while vacuuming
Check for proper installation of the flat
pleated filter.
Ensure the filter cover properly locks
into place.
Replace the flat pleated filter.
Clean the exhaust filters under running
water and let them dry off.
Automatic shut-off (wet vacuum
cleaning) does not react
Clean the electrodes as well as the
space between the electrodes with a
brush.
Continuously check the filling level in
case of non-conductive liquid.
Dry the flat-fold filter.
Dry the exhaust filter.
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.
Accessories and Spare Parts
Only use accessories and spare parts
–
which have been approved by the man-
ufacturer. The exclusive use of original
accessories and original spare parts
ensures that the appliance can be oper-
ated safely and trouble free.
At the end of the operating instructions
–
you will find a selected list of spare parts
that are often required.
For additional information about spare
–
parts, please go to the Service section
at www.kaercher.com.
4
-
EN
Warranty
15