Cables: Conventional Key-In-Knob - Schlage Kryptonite KS Serie Mode D'emploi

CONVENTIONAL
KEY-IN-KNOB CYLINDER
1
2
3
5
6
7
8
When repinning cylinder for use in cable locks you
must use the cylinder cap (KZ34CA0) and cylinder cap
pin (KZ34ED0) from Service Repair Kit (KZ390AL).
PARTS
ITEM
1. Dust Cover Screws
2. Dust Cover
3. Cylinder
4. Cylinder Housing*
5. Driver
6. Lock Head
7. Washer
8. Driver Mounting Screw
9. Cylinder Cap
10. Cylinder Cap Pin
*Cable series can use either Cylinder Housing part
KZ38BA1 or KZ38BA2.
ASSEMBLY INSTRUCTIONS
1. Assemble cylinder and cylinder housing. Make
sure screw hole of cylinder housing is on the
bottom. (Figure 1)
Figure 1
Screw Hole
4
2. Insert the cylinder and cylinder housing into
the lock head. (Figure 2)
Note: Cylinder & key must be positioned as
shown. If cylinder does not slide in easily, turn
key slightly until cylinder falls in place.
Figure 2
3. Rotate the lock head, holding the cylinder in
place, drop the washer into the locking hole.
(Figure 3)
9
Note: Washer must be positioned as shown.
Figure 3
10
ITEM #
KZ36EB0
KZ36EA0
4. Drop the driver mounting screw into the lock-
ing hole and tighten using a 3mm Allen Wrench.
(Figure 4)
KZ38BA1
KZ38BA2 Figure 4
KZ34DA0
KZ33DB0
KZ33DC0
KZ34CA0
KZ34ED0
5. Place the dust cover in position. (Figure 5)
Figure 5
6. Insert the dust cover screws and tighten with a
2mm Allen Wrench. (Figure 6)
Figure 6
The cable lock is now assembled.
Check Function: To lock cable, turn key clockwise
and insert cable end into lock head. Turn key 90
degrees clockwise to unlock cable.
Product is only available with Key Retaining
function.
NOTE ON CYLINDER PINNING
Conventional Key-In-Knob and SFIC service
manuals are available from Schlage for
additional information on cylinder pinning, key
cutting, and key control procedures.
When pinning padlock cylinders, install driver in
position shown below.
Washer
Standard

Cables: Conventional Key-in-Knob

Primus
7