VC-8900-EN 4/16/02 3:39 PM Page 9
MAINTENANCE OR REPLACEMENT OF THE FILTERS
INLET FILTER
The secondary filter, located behind the grille in the back of dust bag compartment, protects the motor from
dirt particles.
Do not allow the filter to become clogged.
Suction power reduction or motor damage may result. If filter becomes dirty, pull off the grille and lift out filter.
After cleaning the secondary filter attach it in place.
NOTE :
The filters must be completely dried before being replaced in the dust compartment.
OUTLET FILTER
Open the dust cover and lift off the grille.
For HEPA Filter Type
HEPA Filter
Preliminary
Filter
Grasp filter and pull it out with preliminary filter.
After cleaning preliminary filter, reposition new filter
and preliminary filter by reversing this procedure.
For Micro Filter Type
Grille Filter
Micro Filter
Preliminary Filter
Grasp grille filter and pull it out with preliminary filter.
After cleaning preliminary filter, reposition new filter
compartment and preliminary filter by reversing this
procedure.
EN-8