Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
2
TO INSTALL SHOWER ARM
Slide flange (3) onto long end of shower arm
(2).
Wrap both ends of shower arm with
plumbers' tape and screw long end of shower
arm into pipe ell inside the wall until tight and
the short end points straight forward. Push the
flange to the wall.
2-3"
TUB SPOUT INSTALLATION
1/2" copper lookout (pipe protruding from wall)
must be 2 3/4" (70mm) min. to 3 3/4" (95mm)
max. in length and be free of deep scratches,
dents, kinks or bends. The cutoff end must be
free of burrs inside and out. Use of a tubing
cutter is recommended.
IF USING ADAPTER TO INSTALL SPOUT
WITH IPS CONNECTION:
Apply Teflon tape to thread and install into IPS
connection. Tighten with 9/16" socket wrench.
3
3
TO INSTALL SHOWERHEAD
Thread showerhead onto shower arm. Tighten
showerhead using a wrench on the flats located
on the shower ball. Hold shower arm with one
hand while tightening.
2-3"
DO NOT use an open end wrench. Cut off 2 3/4-
3 3/4" from finished wall surface. Use of a tubing
cutter is recommended.
TO INSTALL SLIP FIT SPOUT:
Press and twist tub spout (8) onto the lookout
upside down and tightly up against the wall.
Tighten set screw with a 3/32" hex wrench until
it just starts to bind. Turn spout upright into
position against the wall and finish tightening
the set screw. DO NOT OVERTIGHTEN.
8
Lookout Pipe
2
3
/
- 3
3
/
"
4
4
Finished Wall
Publicité
