Chauvet Professional COLORADO BATTEN 144 TOUR Guide De Référence Rapide page 3

COLORado™ Batten 144 Tour QRG
Power Linking
AC Plug
Fuse
Replacement
DMX Linking
DMX
Connection
Master/Slave
Connection
Mounting
Product
Mounting
Diagram
You can link up to 3 COLORado™ Batten 144 Tour products at 120 VAC or
5 at 230 VAC. Power linking cords can be purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect the product.
2. With a Phillips #2 head screwdriver, unscrew the fuse holder cap.
3. Remove the blown fuse and replace it with a good fuse of the same type
and rating.
4. Screw the fuse holder cap back in its place and reconnect power.
The COLORado™ Batten 144 Tour will work with a DMX controller using a
regular DMX serial connection. A DMX Primer is available from
www.chauvetprofessional.com.
The COLORado™ Batten 144 Tour uses a regular DMX data connection for its
DMX personalities: TOUR, BLOCK1, BLOCK2, ARC1, ARC1 + D, ARC3,
ARC3 + D, ARC3 + S, and HSV. See the User Manual to connect and configure
for DMX operation.
The COLORado™ Batten 144 Tour uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure for
Master/Slave operation.
Before mounting this product, read the
clamp is capable of supporting the weight of the product. For our Chauvet line of
mounting clamps, go to
clamps/.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
Safety
trusst.com/productcategory/base-plates-accessories-
Mounting Clamp
Overhead Mounting
Floor Mounting
3
Screw Color
Brown Yellow/Brass
Blue
Green
Notes. Make sure the mounting
Safety Cable
EN
Silver