jbc ADVANCED Serie Manuel D'instructions page 6

ENGLISH
- WRONG TOOL.
Possible causes: use of a tool which is not
compatible with the station for example the
solder feed iron.
- OVERHEAT. To prevent overheating and
damaging the station circuit, you must wait till
the temperature of the circuit goes down and
the station will automatically be ready to work.
Possible causes: very thick and repetitive
soldering jobs.
Once you correct the above mentioned causes,
the station will start working automatically, except
if there is an excess in energy supply (MAXIMUM
POWER). In this case, the station has to be
switched off and restarted.
Stand cable extension
Stand cable extension
Ref. 0781286
Lenght: 1.5 m
It is possible to extend the stand cable by
means of an accessory called "stand cable
extension", Ref. 0781286. By doing so, the user
can have the control unit further away from the
tools and off his/her work table.
For the aspiration tube of the desoldering iron,
a silicone tube extension kit, Ref. 0781287, has
also been manufactured.
For both kits, the length of the cable is 1.5 m.
JBC reserves the right to make technical changes without prior
notification.
4
Silicone tube
extension kit
Ref. 0781287
Lenght: 1.5 m