Description Of Possible Configurations With The Necessary Components And Settings; Configuration Options; Electrical Post-Heating - Helios KWL-EM eC Notice De Montage Et D'utilisation

Operating Instructions
CHAPTER 5
CONFIGURATION
NOTE
NOTE
NOTE
Extension module KWL-EM eC for easyControls
Description of jumper and DIP switch:
Jumper 1:
Jumper 2:
Jumper 3:
DIP 1:
DIP 2:
Possible application of KWL-EM eC:
1. Electrical post-heating (SS-1424)
2. WW post-heating (SS-1425)
5�1 Description of possible configurations with the necessary components and set-
tings
The ventilation unit must be updated before the initial configuration of the KWL-
EM eC�
The following options are available.
Update via the internet:
1. Connect your ventilation unit to your router using a LAN cable.
2. Access the local web server, as described in the ventilation unit installation and ope-
rating instructions.
3. Select the menu item Settings.
4. Enter the unlock code and unlock the settings menu.
5. Go to Connect on the Cloud service submenu.
The ventilation unit will now directly download and install the latest software version in
the background.
Update via KWL-BE Touch:
1. Download the latest easyControls 3.0 firmware at www�heliosventilatoren�de in the
Service area under Software.
2. Save this file to an empty Micro SD card and turn off the ventilation unit.
3. Insert the Micro SD card in the card slot on the connected KWL-BE Touch and turn
on the ventilation unit again.
4. The update will start automatically in the background.
The KWL-BE Touch updates itself directly when it is restarted, afterwards the unit
update is started� The update process of the ventilation unit takes up to 60 minutes
with the KWL-BE Touch�
The ventilation unit automatically detects whether a KWL-EM eC is connected�
5�1�1 Configuration options
The unit can be configured via the KWL-BE Touch controller, via the local web server,
via a mobile device (e.g. notebook, PC, tablet, smartphone). The registration of the unit
is not required.
Registration with a username and password is required to use the easyControls cloud
service.
Leave position unchanged.
Leave position unchanged.
Leave position unchanged
Heating type
Adress KWL-EM eC
5
EN
or