Connection Of The Control Board - Helios KWL-EM eC Notice De Montage Et D'utilisation

Operating Instructions
EN
m
WARNING
Extension module KWL-EM eC for easyControls
m
The safety instructions in section 1�2, 1�3 must be observed!
1. Open the casing cover.
2. Slide the cable glands on the connection cable (right side el. connection cable, Mod-
bus connection cable) (left side sensor cable, power supply for accessories).
3. Thread the locknut on the cable in the terminal box and fix the cable gland.
4. Carry out the wiring according to the wiring diagram (see section 6.2/6.3) and appli-
cation (see section 6.1).
5. Hand-tighten the cable glands.
6. Seal the remaining openings with membrane grommets.
A
Fig�2
4�2 Connection of the control board
Fig�3
ä
ù
Terminal block low voltage
Terminal block 230V
ò
4