stayer GAS CUTTER 33 Instructions D'emploi page 29

- Fill fuel tank with proper fuel / oil mixture. See Fuel
and Lubrication Section.
TROUBLE SHOOTING
16.
PROBABLE
PROBLEM
CAUSE
Incorrect starting
procedures.
Incorrect carburettor
mixture adjustment
Unit won't start or
starts but will not
run. Fouled sparking plug.
Empty fuel tank.
Primer bulb was not
pressed enough.
Fuel filter is plugged.
Incorrect lever
position.
Dirty spark arrester
Unit starts, but
engine has low
power.
Dirty air filter.
Incorrect carburettor
mixture adjustment
setting service
Incorrect carburettor
mixture adjustment
Engine sputters.
Air filter is blocked.
Old or improperly
mixed fuel.
Incorrect carburettor
mixture adjustment
Old or improperly
No power under
mixed fuel.
load.
Air filter is blocked.
Fouled sparking plug.
Incorrectly gapped
sparking plug.
Blocked spark
Runs erratically.
arrester.
Dirty air filter.
Incorrect carburettor
mixture adjustment
Smokes
excessively.
Incorrect fuel
CORRECTIVE
ACTION
Follow instructions in
the User Manual.
Have carburettor
adjusted by an
Authorized Service
setting.
Centre.
Clean/gap or replace
plug.
Fill fuel tank with
properly mixed fuel.
Press primer bulb fully
and slowly 10 times.
Replace the fuel filter.
Move to RUN position.
Replace spark arrester
screen. screen.
Remove, clean and
reinstall filter.
Have carburettor
adjusted by an
Authorized Service
dealer. Centre.
Have carburettor
adjusted by an
Authorized Service
setting.
Centre.
Replace or clean the
air filter.
Drain gas tank/add
fresh fuel mixture.
Have carburettor
adjusted by an
Authorized Service
setting.
Centre.
Drain gas tank /add
fresh fuel mixture.
Replace or clean the
air filter.
Clean/gap or replace
plug.
Clean/gap or replace
plug.
Clean or replace spark
arrester.
Clean or replace air
filter.
Have carburettor
adjusted by an
Authorized Service
setting.
Centre.
Use properly mixed
mixture. fuel (40:1 mixture).
ENGLISH
29
REPAIR SERVICE
17.
The technical service will provide you advice regarding
questions you may have on the repair and maintenance
of your product as well as on spare parts.
You may also obtain exploded views and information on
spare parts on the internet under:info@grupostayer.com
DISPOSAL AND RECYCLING
18.
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According the European Guideline 2012/19/
CE for Waste Electrical and Electronic
Equipment and its implementation into national right,
power tools that are no longer usable must be collected
separately and disposed of in an environmentally correct
manner.
Subject to change without notice.
29