Tripp-Lite BP Serie Manuel De L'utilisateur page 4

Mounting (Rack)
Mount your rackmount battery pack in either a 4-post or 2-post rack or rack enclosure
(see page 6 for 2-post mounting). The user must determine the fitness of hardware and
procedures before mounting. If hardware and procedures are not suitable for your
application, contact the manufacturer of your rack or rack enclosure. The procedures
described in this manual are for common rack and rack enclosure types and may not be
appropriate for all applications.
4-Post Mounting
Most external battery packs include the hardware required for 4-post mounting. If this
hardware did not come with your unit, an Adjustable 4-Post Rackmount Shelf Kit
(Model 4POSTRAILKIT) may be ordered separately.
1
The included plastic pegs
B while you install the permanent mounting hardware. Insert a peg near the center
of the front and rear bracket of each shelf as shown. (Each front bracket has
6 holes and each rear bracket has 3 holes.) The pegs will snap into place.
After installing the pegs, expand each shelf to match the depth of your rack rails.
The pegs will fit through the square holes in the rack rails to support the shelves.
Refer to the rack unit labels to confirm the shelves are level in all directions.
Note: The support ledge of each shelf must face inward.
A
1
18-09-336 93-36FF.indb 4
A will temporarily support the empty rackmount shelves
B
A
A
B
4
A
12/18/2018 8:26:57 AM