Tripp-Lite BP Serie Manuel De L'utilisateur page 11

Connection
1
Select battery packs have a polarized plug
on an output cord permanently connected to
the rear panel. Simply plug the output cord
directly into the UPS external battery
connector (refer to the UPS manual for
external battery connector description and
location).
Note: Only one of these battery packs is generally
connected to a UPS at one time. For longer
runtime, use one or more Tripp Lite Battery Packs
with daisy-chain capability.
2
Select battery packs feature daisy-chain
capability for longer runtime
a UPS, insert one end of the attached cable
C into either plug on the rear of the battery
pack and the cable's other end into the
external battery connector of your UPS.
(See your UPS manual for external battery
connector description and location.) To
connect multiple battery packs to a single UPS for greatly increased runtime,
connect the output of the first battery pack to the UPS system's external battery
connector, then "daisy-chain" the others: connect an input/output plug on the
second battery pack to an input/output plug on the first, a plug on the third to a
plug on the second and so on.
Note: Multiple battery pack arrays will provide longer runtimes, but will also require longer
recharge times.
3
Select battery packs contain an external battery detection port on the rear panel.
The battery packs should only be used with host UPS models that provide the same
functionality. The UPS will automatically detect the external battery upon connection
with the battery communication cable
external battery pack models, configuration requirements and potential limitations.
Battery packs are for use only with UPS systems supporting external battery pack
detection cabling (this connection is not required if the UPS does not support this
feature).
UPS
3
18-09-336 93-36FF.indb 11
A
B . To connect to
D . Check the UPS manual for compatible
D
11
1
B
C
2
A
Battery
Pack
12/18/2018 8:27:05 AM