Miter Gauge Adjustment; Table Stop Adjustment - Jet Tools JWBS-10 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Disconnect machine from power source.
For upper blade guide, loosen two thumb-screws (F). For
lower blade guide, loosen two setscrews (F) with the
3mm hex wrench provided.
Slide adjustment shaft (G) to position each guide bearing
(H) approximately 1/16" behind the gullets of the saw
blade.
The guide bearing (H) is mounted on a concentric shaft.
When the shaft (G) is rotated, the relative position of the
guide to the blade can be changed.
Rotate each adjustment shaft (G) to position the guide
bearings (H) within 1/32" of the saw blade.
Secure the guide bearings (H) by tightening
thumbscrews (F, upper guide) or setscrews (F, lower
guide).

7.6 Miter gauge adjustment

Refer to Figure 28:
To adjust angle of miter gauge, loosen handle (J) and
rotate gauge body. Tighten handle.
Place miter gauge into table slot and use a square to
verify that 90-degree setting on scale is 90-degrees to
slot. Adjust pointer (K) if necessary.
Fig.27
Fig. 28
7.7 Tilting table
Refer to Figure 29:
Loosen lock knob (A).
Tilt table up to 45 degrees to the right or down 5 degrees
to the left. The angle can be read on the scale (B) on the
trunnion bracket.
Note: Table perpendicular (90º) to the blade corresponds
to a scale indication of 0º.
Tighten lock knob (A).
Note: The table stop (C) must be adjusted to permit the
table to tilt to the left.
NOTE: Lock handle (A, Figure 29) is adjustable – pull
down on handle and rotate on pin. Release handle,
making sure it settles back onto pin.
7.8 90º Table Stop Adjustment
7.8.1 Adjusting table stop
Refer to Figures29 and 30.
The table stop (C, Figure 29) is typically set to stop the
table at 90º (perpendicular) with the blade.
Disconnect machine from power source.
Loosen lock knob (A, Figure 29); then tilt table down,
bringing it to rest against table stop (C, Figure 29).
Fig.29
Fig.30

Publicité

Table des Matières
loading

Table des Matières