Assembly - Jet Tools JWBS-10 Mode D'emploi

Stability of bandsaw.
Before using the bandsaw, ensure the machines upright
stability is satisfactory.
The bandsaw has three Ø8mm holes (A, Fig 5 Fig.6 Fig.7)
in it's base to allow it to be bolted to a workbench or to the
supplied open stand
Fig. 5
Fig.6
Fig. 7
For packing reasons the machine is not completely
assembled.
Refer to Figure 6,Figure 7 to assemble stand. Use carriage
bolts (HP3) and flange nuts (HP9) throughout. Only hand-
tighten all fasteners at this time.
Make sure the two short support plates with extra holes (M)
are opposite one another as shown.
Slip rubber feet (L) onto ends of stand legs.
Place stand upright on level floor, and push down until it sits
evenly.
Tighten all nuts on stand assembly.

5.2 Assembly

If you notice any transport damage while unpacking, notify
your supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly
manner.
Clean all rust protected surfaces with a mild solvent.
Prior to use, the following items have to be fitted:
Bandsaw table, Rip fence guide and Crank handle.
Fitting the table
Refer to Figure 8.
Loosen lock handle (shown in Figure 9) and pivot trunnion
(A1) to horizontal position.
Loosen lock knob (C2) and pull extension (C1) out from the
table (C).
Orient table as shown, then maneuver to allow saw
blade (A2) to pass through slot (C3) to the center.
Line up four threaded mounting holes underneath table with
the four mounting through-holes on trunnion.
Important: Adjust table so miter slot (C
saw blade (A ).
2
Secure with four M6x12 hex washer head screws (HP2).
Tighten with 13mm wrench.
Fitting Guide rail and fence
Attach guide rail (E, Figure 9) to front of table. Secure with
four wing screws (HP4) and flat washers (HP5).
) is parallel with
4
Fig. 8