Blade Tracking Adjustment - Jet Tools JWBS-15 Mode D'emploi

Release the blade tension by operating the quick blade
tension lever (Q, Fig 30) and by turning the blade tension
hand wheel (L).
Open the blade guards (Fig 31, Fig 32)
Fig 29
Fig 30
Fig 31
Fig 32
Remove the dust block (J, Fig 33)
Install new saw blade.
After the new saw blade is installed, tighten the sawblade
sufficiently.
Follow the scale (M, Fig 34).
Install the dust block (J).
Close the blade guards.
Close the wheel covers.

7.3 Blade tracking adjustment

Blade tracking shall never be performed when the machine is
running.
The sawblade must run on the centre of the rubber tyres (Fig
35).
Fig 33
Fig 34
Fig 35