Hama Color EWS-1200 Mode D'emploi page 7

Note
• Initial setup takes approx. 3 minutes.
• Do not press any buttons during setup.
Otherwise, values may not be transmitted
correctly and there is a risk of value errors and
inaccuracies.
• The setup process is completed when the
indoor (7/8) and outdoor (7/8) measurement
data is displayed.
• If the base station still does not receive a signal
from the measuring station, press and hold the
LIGHT / CHANNEL / Zz button (10) for approx. 3
seconds to start the manual search for the signal.
• You can also press the TX button (24) to enforce
transmission
6.3. Selecting the channel/other measuring
stations
Note
You can install two more measuring stations
in addition to the included measuring station.
Ensure that the base and measuring stations are
set to the same channel. Visit www.hama.com for
suitable measuring stations.
• Press the LIGHT / CHANNEL / Zz button (10)
repeatedly to set the channel to that set on
the respective measuring station – see 4.1.
Measuring station . INDOOR, CHANNEL 1,
CHANNEL 2 or CHANNEL 3 (5) is displayed.
• The base station now shows the data measured
(7/8) on the selected measuring station (5).
• Press AUTO – button (13) repeatedly to turn on or
off the auto-scrolling display mode.
6
• AUTO icon appears when the auto-scrolling
mode is enabled and the display will interchange
between indoor & outdoor display automatically.
6.4. Basic and manual settings
Automatic setting using the DCF signal
• After the first time the base station is switched
on and successful transmission is established
between the base station and the measuring
station, the clock will automatically search for a
DCF signal. During the search, the wireless symbol
(6) will flash.
Display
Display flashing
Displayed continuously
Not displayed
• If the station still does not receive a signal, press
and hold the + button (12) for approx. 3
seconds to start the manual search for the DCF
signal. The wireless symbol (6) will start to flash.
Searching for the
DCF signal
Active
Successful –
signal is being received
Deactivated