emerio MG-201798.2 Mode D'emploi page 5

MG-201798.2
DESCRIPTION
1. Hopper plate
2. Motor housing
3. ON/OFF/ Reverse switch
4. R / ON switch
5. Locking knob hole
6. Locking knob
7. Food pusher
8. Head
9. Feed screw
FOR THE FIRST TIME
1. Check that voltage indicated on the rating label corresponds to the mains voltage in your home.
2. Wash all parts (except body) in warm soapy water.
3. Before plugging in, ensure the "ON/OFF/ Reverse" switch is turned to "OFF" position.
FOR USE
ASSEMBLING
1. Place the feed screw into the head, long end first, by turning the feed screw slightly until it is set into the
motor housing (fig.1).
2. Place the cutting blade onto the feed screw shaft with the blade facing the front as illustrated (fig.2). If it is
not fitted properly, meat will not be ground.
3. Place the desired cutting plate next to the cutting blade, fitting protrusions in the slots (fig.3).
4. Support or press the centre of the cutting plate with one finger then screw the fixing ring until tight with
another hand (fig.4). Do not over tighten.
5. Holding the head and insert it in the inlet with one hand, tighten it by turn the LOCKING KNOB clockwise
to secure the head (fig.5, 6).
6. Place the food chute on the head and fix into position.
7. Locate the unit on a firm place.
8. The air passage at the bottom and the side of the motor housing should be kept free and not blocked.
10. Cutting plate (fine)
11. Cutting plate (medium)
12. Cutting plate (coarse)
13. Fixing ring
14. Cutting blade
15. Sausage attachment
16. Kibbe attachment
17. Head inlet
- 4 -
EN