Johnson Pump SPX Flow Twin Port 12V Manuel D'instructions page 10

• To reinstall, first make sure the "O" Ring is properly
located.
Coat the "O" Ring with a light film of vegetable oil or
mineral oil, then align the two cams on either side of
the power cartridge with the two slots in the outer
housing. Press down and twist in a clockwise rota-
tion. To ensure that the power cartridge is properly
located, twist fins in a counter clockwise direction
without lifting tab. Cartridge should stay in place.
Mounting of the Twin Port Live Well Pump
The Twin Port pump is designed to thread directly
into a ¾˝ NPTF ball valve or seacock. Pump is not self
priming and must be mounted below the water line to
ensure adequate performance. Pumps mounted th-
rough the transom will only operate while the boat is
at idle or a slow troll. Pumps mounted through the bo-
ats bottom can provide continuous water flow while
underway or idle when coupled with a high speed low
or high flow water pick up.
10
Original instructions