Publicité
Les langues disponibles
Les langues disponibles
AdjUSTINg THE dUST BlOwER
For best results, the dust blower tube should be adjusted to direct air at
both the blade and the workpiece.
SAwdUST COllECTION
this scroll saw allows a hose or vacuum accessory (not provided) to be
connected to the sawdust collection port (fig 4).
If excessive sawdust buildup occurs inside the base, use a wet/dry vacuum
cleaner or manually remove sawdust by removing the screws and metal
plate on the left side of the saw. re-attach the metal plate and screws
before starting the saw. This will keep your saw cutting efficiently.
BlAdE SElECTION
this scroll saw accepts both both pin-end and plain-end 5" length blades,
with a wide variety of blade thicknesses and widths. the type of material
and intricacies of cutting operations will determine the number of teeth per
inch. always select the narrowest blades for intricate tight radius curve
cutting and the widest blades for straight and large-curve cutting
operations.
BlAdE REmOVAl ANd INSTAllATION
wARNING! To reduce the risk of injury always turn saw OFF and
disconnect the plug from the outlet before removing or replacing the
blade.
this saw uses both pin-end and plain-end blades. Pin-end blades are
thicker for stability and for faster assembly. they provide faster cutting on a
variety of materials.
NOTE: When installing pin-end blades, the slot on the blade holder
must be slightly wider than the thickness of the blade. After the blade is
installed, the blade tension mechanism will keep it in place.
1. Release blade tension by loosening the blade tension knob (H, fig 1).
2. remove the table insert by carefully prying it up.
3. Loosen the upper blade holder screw (V, fig 5) and lower blade holder
screw.
4. Push down on the upper blade holder to remove the blade from the
holder.
5. remove the blade from the lower blade holder.
6. Install a new blade with the teeth pointing downward. If the blade is
installed with the teeth pointing upward, the workpiece will tend to pull
up from the table and will lead to vibration or possible loss of control of
the workpiece.
7. to install the blade, hook the blade in the recess of the lower blade
holder.
8. While pushing down on the upper blade holder, insert the blade into the
slot of the holder.
9. tighten the upper and lower blade holder screws. Pinless blades use
strictly the clamping action of these screws to hold them.
10. To tension the blade, tighten the blade tension knob (H, fig 1). Make
sure the blade is properly located in the blade holders. turn the blade
tension knob until light finger pressure on the side of the blade moves
it about 1/8" (3 mm). this amount of blade pressure should do well for
most cutting operations.
11. snap the table insert back into place.
!
150311
9
Publicité
