Publicité
Les langues disponibles
Les langues disponibles
ARm BEARINg lUBRICATION
● Lubricate the arm bearings with oil after 10 hours of use.
● re-oil after every 50 hours of use or whenever there is a squeak
coming from the bearings.
1. remove the two rubber bearing covers on one side.
2. turn saw on its side.
3. apply a generous amount of sae 20 oil around the shaft end and
bronze bearing.
4. Let the oil soak in overnight in this position.
5. the next day, repeat the above procedure for the opposite side of the
saw.
NOTE: In case of an electrical fault always turn your power tool OFF
and disconnect from the mains electric supply before attempting to
diagnose and resolve the problem.
● an authorized repair center should do any repairs, modification, or
maintenance that involve disassembling the saw.
● any damage to the tool should be corrected at an authorized repair
center. Contact General International concerning repairs.
wARNING! Never use flammable or combustible solvents around tools.
wARNING! To reduce the risk of injury, electric shock and damage to
the tool, never immerse your tool in liquid or allow liquid to flow inside the
tool.
12
!
!
Publicité
