How To Attach The Stand - JVC LT-19HA22U Mode D'emploi

Important safety information

How to attach the stand

NOTE:
• Unplug the AC cord from the AC INPUT terminal.
• Before beginning this process, assure that TV is laid on a clean, safe, and cushioned space to avoid any
damage to the unit.
• Do not touch or press the TV-screen, glass might break under pressure.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1) Place the TV on its front onto a table.
2) Align the stand's bottom-plate (supplied) as seen here.
It will fit in only one direction.
3) Hold the unit and attach the stand slowly. Finally secure the bottom-plate with 2 screws (included).
LT-19... / LT-22...
LT-26... / LT-32...
Pull out 2 plates (see illustration). Fix to the appropriate ground with the supplied screws.
Note: There is no liability for any damage to the ground.
NOTE:
• To detach the stand, perform these steps in reverse order.
Dismantling the base
For wall mounting, the base must be dismantled. To do this, remove 3 screws (M, see page 10) from the
back. Take off the base entirely.
Warning
(only for LT-32...)
To prevent injury, which could be expec-
ted due to an eventual fall, the TV should
be fixed to the ground according to
instruction (see below).
5