Chauvin Arnoux MN93 Notice De Fonctionnement page 14

Thank you for purchasing a MN93, MN93A, C193 or PAC93 AC current clamp
or an AmpFLEX A193 flexible current sensor. This accessories should only be
used with the C.A 8220, C.A 8230, C.A 8332, C.A 8334 and C.A 8335 analysers.
To obtain the best service from your unit:
„ read these operating instructions carefully,
„ comply with the precautions for use.
WARNING, risk of DANGER! The operator agrees to refer to these
instructions whenever this danger symbol appears.
Equipment protected by double insulation.
Application or withdrawal authorized on conductors containing danger‑
ous voltages. Type A current sensor as per IEC 61010‑2‑032.
Must not be applied to or removed from conductors at dangerous
voltages. Type B current sensor as per IEC 61010‑2‑032.
The arrow indicates the current phase.
Battery.
The CE marking guarantees conformity with European directives.
The rubbish bin with a line through it means that in the European Union,
the product must undergo selective disposal for the recycling of electric
and electronic material, in compliance with Directive WEEE 2002/96/EC.
Definition of measurement categories:
„ Measurement category IV corresponds to measurements taken at the source of
low‑voltage installations.
Example: power feeders, counters and protection devices.
„ Measurement category III corresponds to measurements on building installations.
Example: distribution panel, circuit‑breakers, machines or fixed industrial devices.
„ Measurement category II corresponds to measurements taken on circuits directly
connected to low‑voltage installations.
Example: power supply to electro‑domestic devices and portable tools.
„ Measurement category I corresponds to measurements taken on circuits not
directly connected to the network.
Example: protected electronic circuits.
ENGLISH
14