Koala Kare KB200-SS Mode D'emploi page 5

KB200-SS
Important:
In Step 3, SIX screws must be mounted to the
chassis to ensure proper load bearing capacity!
Use only screws and hardware appropriate for the
type of wall where the baby changing station is
being mounted.
Installation Instructions
Step 3. Mount Bed and Chassis
Use only screws and hardware appropriate for
the type of wall where the baby changing station
is being mounted. Tighten top two screws so that
they are flush with the wall. Use the four lower
holes as a guide to mark and drill pilot holes.
Use remaining four screws and four washers
to complete installation of bed and mounting
bracket. Insert washers over lower four screws. All
SIX screws and four washers must be mounted to
the chassis.
Step 4. Install Liner Dispenser
Ensure liner dispenser is free from damage.
Remove key, unlock, and open liner dispenser
lid. This will expose liner dispenser mounting
holes. Line up dispenser mounting holes
onto chassis and secure with the four screws
provided. Close and lock the liner dispenser door.
Step 5. Complete Installation
Inspect unit to ensure it opens and closes
smoothly. Clean gently with a stainless
steel cleaner, following the manufacturer's
recommended cleaning instructions. Clean
work area. Give Operator Kit and key to the
facility operator. Replacement parts and
additional liners can be purchased from
your local distributor or by calling Koala at
1.303.539.8300.
Before mounting this changing station, ensure
the wall surface where the unit will be mounted
can support a maximum weight of 150 kg.
4