Koala Kare KB200-SS Mode D'emploi page 4

KB200-SS
Step 2. Prepare Mounting Surface
Please identify the appropriate hardware for the
mounting surface.
For Standard Installation
Remove the bed and chassis from the box and
select the wall area where the unit will be installed.
Make sure you have taken into consideration the
operating clearance of 24.1 cm on both sides of
the exposed chassis and 58.9 cm from wall surface
when open. Measure from the floor 107 cm on
stud center and mark the wall. The mounting holes
are designed for 40.6 cm stud centers. Ensure the
locations you have marked for the mounting holes
are level before drilling. Drill pilot holes for keyhole
mounting using a 3 mm regular drill bit.
For Masonry or Tile over Stud Wall
Use a 5 mm masonry drill bit for the pilot hole until you
hit the stud. Change bit to 3 mm regular drill bit.
For Metal Stud or Concrete Block
If the wall has wood studs that are not on 40.6 cm
centers, has metal studs or an underlying surface of
concrete block, drill with a 12 mm masonry bit. (You
may have to purchase toggles before installing.)
You must allow a minimum of inside wall space for
toggles to turn depending on toggles used. Insert
and tighten toggles.
Installation Instructions
Frame is equipped
with keyhole slots
to assist with
mounting.
Floor
3
9
1 /2
"
(2 4 1 m m
)
"
2 3 3 /1 6
)
(5 8 9 m m
16"
(406.4mm)
Top two screws at
42¼" (107 cm) to
meet ADA Height
9
1 /2
"
(2 4 1 m m
)
Requirements