Fixing; Electrical Connection; Water Connection; The Whispa - Myson WHISPA III 5000 WM Manuel D'installation, D'utilisation Et D'entretien

32356 WHISPA III Manual US+French.qxp_Layout 1 19/03/2018 11:57 Page 5
®
04 WHISPA III 5000 WM & 9000 WM

5.0 Fixing

(continued...)
l The WHISPA III
®
wall units are designed so that the piping
and wiring connections are made within the cabinet of the
unit itself. The installer should inspect the unit and note that
" piping should enter on the lower right hand corner of
1
the /
2
the unit and the 110V AC wiring for the unit enters on the
lower left hand corner of the unit, see Fig 2.
l Prepare the opening in the wall to accept the unit as shown
in Fig 1. Depending on the wall framing layout, the 9000
Dimensions of opening to be cut in wall
"
/
17 3
4
Fig.1
Note: Both models require a depth of at least 3

6.0 Electrical Connection

WARNING: This appliance must be grounded.
l The electrical installation must comply with
local or national wiring regulations.
l A hole is provided at the lower left hand
corner of the unit for BX or Romex convector.
Do not energize the electrical supply until the remaining stages of the installation have been completed.

7.0 Water Connection

l Depending on the wall construction, the installer will need to
decide whether it would be best to fit the unit first and then
bring in the piping, or to bring the piping in first. Once this
decision has been made, place the unit in position (fan at
bottom) and secure to the framing with suitable screws. Use
all the fixing holes, see Fig 2.
l Bring " copper tubing from the heating loop to the unit
1
/
2
and make sweat connections.
"
/
14 1
2
5000 WM Model
1 "
/ .
2
model may require re-framing of the opening to ensure
proper support.
l Do not fit the unit at this stage. Consideration should be
given to making the electrical connection (section 6) and
making the connection to the hot water circuit (section 7)
prior to fitting the unit into the wall cavity.
/
18 1
"
/
17 3
4
9000 WM Model
l Remove the electrical panel cover to make the electrical
connection.
Black lead - Hot 120V AC 60Hz
White lead - Neutral
Ground Lug - Ground
l Use suitable sized wire connectors and replace the electrical
panel cover.
l Many installers are now beginning to use flexible heat tubing
to make these connections. Ensure prior to use that the
tubing selected is appropriate for the water temperature to
be supplied.
EN
"
4