Power Fist SMART TIG AC/DC-200P Manuel De L'utilisateur page 9

V4.1
D Shield Gas Connector – Connect to the gas input line for the torch.
E Power Source Switch – ON/OFF switch for the welding unit.
F Power Source Input – Attach to power supply cord.
G Shield Gas Input – Connect to gas hose from gas cylinder. Gas will flow through and exit out of the Shield Gas
Connector (D) to the torch.
CONTROL PANEL
1. AC/DC selecting key - AC welding - AC 0, DC welding - DC 0
2. I-Spot key - Lights up when I-Spot key is pressed with 2T welding mode, DC welding and HF ignition mode. When I-
spot is active, up slope and down slope are not active.
3. Gas-test key - Lights up when gas-test key is pressed, after that gas will flow out for 5 seconds. Press the key again
to stop the gas flow before the 5 seconds are up.
4. HF ignition key - Lights up when high frequency key is pressed, HF (high-frequency) ignition has been selected.
5. Pulse key - Lights up when Pulse key is pressed. Pulse has been selected.
6. Left parameter selection key - It is possible to change parameter indicator by means of the parameter selection
keys (6) and (8) while the welding operation in progress.
Important! After the start of welding, you can only change the parameters related to the current.
7. Parameter adjusting dial - If the parameter indicator lights up, then the selected parameter can be altered on
adjusting dial. Slower rotational encoder, the number increased by 1; otherwise an increase of 5.
8. Right parameter selection key - It is possible to change parameter indicator by means of the parameter selection
keys (6) and (8) while the welding operation in progress.
Important! After the start of welding, you can only change the parameters related to the current.
9. MMA welding selection key
Force - Arc Force with a setting range of 0 to 10
Hot - Hot Start with a setting range of 0 to 10
Visit www.princessauto.com for more information
SMART TIG AC/DC-200P Inverter Welding Machine 8560237
Fig. 2
Fig. 3
9