Publicité
Initialization Procedure:
STEP
OPERATION
1
Press and hold Λ & V simultaneously until legs stop
moving.
2
Release Λ & V together.
The initialization procedure must be completed before the fi rst running after the desk is installed or parts are replaced.
When a re-initialization procedure is needed, unplug the desk from the wall for 30 seconds before re-initializing,
Move Up and Down:
STEP
OPERATION
1
Press and hold Λ.
2
Release Λ.
3
Press and hold V.
4
Release V.
Set Presets:
STEP
OPERATION
1
Press and hold Λ or V to achieve desired desk height.
2
Press 'S' then press 1, 2, or 3 within the next 3 seconds.
Move Desk Height to a Preset:
STEP
OPERATION
1
Press and hold 1, 2, or 3 until legs stop moving.
Switch Display from Inches to Centimeters:
STEP
OPERATION
1
Press and hold 'S' then press and hold V and hold both
down for 3 seconds.
2
Release the buttons.
The display height changes in intervals of 0.5" or 1cm.
Change the Height on the Display to Match the Actual Worksurface Height:
STEP
OPERATION
1
Set the worksurface to any height, recommended at the
bottom position.
2
Press and hold 'S' then press and hold Λ and hold both for
3 seconds.
3
Release 'S' and Λ buttons then press Λ or V to change the
first digit.
4
Press 'S'.
5
Press Λ or V to change the second digit.
6
Press 'S'.
7
Press Λ or V to change the third digit.
8
Press 'S'.
8 of 12
MOTION
Legs move down at half speed of normal operation to the lowest postition and
rebound 2-5 mm, then stop.
Initialization in complete.
MOTION
Legs move up.
Legs stop.
Legs move down.
Legs stop.
MOTION
Legs move worksurface to desired height.
Position 1, 2, or 3 is saved.
MOTION
Legs return to the corresponding position saved.
MOTION
The height information will be changed between centimeters and inches.
Operation complete.
MOTION
Measure the actual worksurface height and write down the number in inches
or in centimeters.
The fi rst number on the display starts fl ashing.
The fi rst digit is being increased or decreased to the fi rst digit of your
measurement.
The second digit on the display starts fl ashing.
The second digit is being increased or decreased to the second digit of your
measurement.
The third digit on the display starts fl ashing.
The third digit is being increased or decreased to the third digit of your
measurement.
Operation complete.
555-24-002-G-00 rev. B • 04/19
Publicité
