ST SH 500 Li 48 Serie Manuel D'utilisation page 105

The electrical motor is activated by a
on the handle, activating the
The operator can drive the machine by holding it
by the handle where the starter lever is located,
always standing upright behind the machine.
4.1.1 Intended use
This machine was designed and manufactured
for:
• shoveling, clearing and ejecting snow from
footpaths, driveways and other ground-level
surfaces.
• use by one operator.
4.1.2 Improper use
Any other usage not in keeping with the afore-
mentioned ones may be hazardous and harm
persons and/or damage things. Examples of
improper use may include, but are not limited to:
• use of the machine for sweeping;
• use of the machine on surfaces above ground
level, such as roofs on houses, garages,
porticoes or other structures or buildings;
• activating the impeller in the presence of
materials other than snow (e.g. soil, grass,
pebbles, etc.);
• carrying children or other passengers.
• using the machine with more than one person.
IMPORTANT Improper use of the machine will
invalidate the warranty, relieve the Manufacturer
from all liability, and the user will consequently be
liable for all and any damage or injury to himself
or others.
4.2 SAFETY SIGNS
The machine has various symbols on it
(Fig. 2). They are used to remind the operator
of the behaviour to follow to use it with
the necessary attention and caution.
Meaning of symbols:
WARNING! DANGER! The
failure to use this machine
correctly can be hazardous
for oneself and others.
WARNING! Read the
instruction manual before
using the machine.
Use ear protection
devices and goggles.
starter lever
clearing impeller.
EN - 7
DANGER! Rotor turning.
Always keep away from the
snow discharge opening.
DANGER! Keep hands and
feet away from rotating parts.
PROJECTION HAZARD!
Keep any people or pets
at least 15 m away when
using the machine!
DANGER! Before servicing
the machine, remove the
battery from the machine.
DANGER! Do not
expose to rain
WARNING! As regards the
battery and the battery charger,
consult the relative manual
IMPORTANT Any damaged or illegible decals
must be replaced. Order replacement decals from
an authorised service centre.
4.3 PRODUCT IDENTIFICATION LABEL
The product identification labelww provides the
following data (fig. 1):
1. Name and address of Manufacturer
2. Conformity marking
3. Type of machine
4. Sound power level
5. Power supply voltage
6. Month / Year of manufacture
7. Serial number
8. Article code
9. IPX1
Write the identification data of the machine in the
specific space on the label on the back of the
cover page.