POWER SUPPLY
➢ Use only the supplied AC adaptor!
➢ Ensure that the voltage is the same as that indicated on the ac adapter identification plate.
➢ Connect the supplied AC adapter to a properly installed safety power socket and the plug of
the cable into the DC IN jack at the back side of the unit.
POWER ON / OFF
Press "POWER / SOURCE / ALARM OFF" button to turn the unit on.
Press and hold "POWER / SOURCE / ALARM OFF" button to turn off the unit in standby mode.
SELECTING MODES
During playing mode, press the "POWER / SOURCE / ALARM OFF" button repeatedly to switch
between the modes.
ADJUSTING VOLUME
Press the "VOLUME DOWN" or "VOLUME UP" button to decrease or increase the volume.
Extend the antenna to improve DAB signal reception!
1. In on mode, press the "POWER / SOURCE / ALARM OFF" button repeatedly until the DAB
icon is shown in the display to select the DAB mode.
2. At the first start the unit will automatically start the scan function and search all available
stations.
3. During the scan the display will show a slide bar that indicate the progress of the scan and
the number of stations that have been found.
4. After the scan has finished, the unit will select the first found station.
5. To explore the found stations, press " " or " " to select the desired radio station and
confirm with "SELECT".
SCANNING FOR DAB STATIONS
1. In DAB mode, press and hold the "MENU / INFO / BACK" button until "STATION SCAN" is
visible on the display.
2. Confirm with the "SELECT" button the selection.
3. Select with " " or " " the function "FULL SCAN" or "MANUAL TUNE" and confirm again
with "SELECT"
FULL SCAN: Perform a complete station search of the DAB range.
MANUAL TUNE: Select with " " or " " the desired frequency and confirm with "SELECT".
BASIC OPERATIONS
DAB
2
UR6600 / English Instruction Manual