English; Warnings - Leb electronics ARGO230 Instructions Et Avertissements Pour L'installation Et L'usage


This manual is intended only for technical qualified staff and not for end user.
It is up to installer informing user about the automatism and on possible
dangers coming from it, as well as on the need of a periodical maintenance.

The installation is to be done only by qualified staff having necessary
technical and professional requirements.

The product is to be installed respecting rules in force on automated closings.

The device has been realized on purpose to automate sliding gates. Any
other use is to be considered as improper and therefore forbidden.

Always use original components. The firm Leb electronics takes no
responsibility for damages due to use of non original components.

Before going on with installation, make sure that the gate frame is solid and
fitted to device employ.

Before going on with installation, make sure that, during gate shifting, there
are no friction points and that the gate has no possibility to go off the rails.

Before acting on the device, check the feeding voltage is disconnected.

Fix very carefully safety devices to be installed and the place where they
should be put. Furthermore always insert an emergency stop device, allowing
forced interruption of electric feeding.

The equipment should not be handled by children or inexperienced people.

In case of electric voltage lack, raise releasing device to manually open or
close the gate.

The maintenance of the device is to be performed only by qualified staff
authorized by manufacturer.

Any six months carry out the maintenance of the device and check the sliding
wheels of the gate are in a good condition and properly oiled.

WARNINGS

7

ENGLISH