Gear Motor Releasing - Leb electronics ARGO230 Instructions Et Avertissements Pour L'installation Et L'usage

Gear motor releasing

Releasing operation is made by an Allen spanner, which is to be kept by user
in a safe place easily reachable. To handle releasing, act as follows:

Insert the spanner in the hole on the gear motor back. Rotate clockwise
the spanner until stroke end.

To restore usual working, bring back the spanner in its initial position,
rotating it anticlockwise.
Electrical connection
Advices

All connection operations should be carried on without electric voltage.
Stroke end Cable
The device is equipped by two Stroke ends. From the Stroke end block four
wires come out. In the following table there are the data on Stroke end cable,
needed for the connection to control board.
11
ENGLISH