Siemens SITRANS F Mode D'emploi page 34

Commissioning
3.5 Sensor Installation
Save/Rename Site Procedure
Whenever new site configurations are added to an existing site that site must be saved again
to retain the new site changes.
1. To save all programmed data to site, trigger <Left Arrow> and then scroll up to [Channel
Setup].
2. Trigger <Right Arrow> and scroll to [Save/Rename Site].
3. Trigger <Right Arrow> and then <ENTER> to save all programmed data to site.
4. To return to the top menu level, continue to trigger the <Left Arrow>.
3.5 Sensor Installation
3.5.1 General information
Reflect and Direct Mounting Modes
Reflect and Direct mounting modes are supported for clamp-on sensors. The transmitter
recommends a mounting mode after analyzing your pipe and liquid data entries. This Quick
Start illustrates a typical sensor setup using the Reflect Mode.
Note
For Direct Mount refer to the Operating Instructions manual.
Mounting Supplies
The following items will be needed to mount the sensors (most are supplied):
● Flat blade screwdriver
● Mounting Frames or Mounting tracks
● Tape, chalk and a ruler or measuring tape
● Mounting Straps
● Spacer Bar
● Mounting Guide (for Direct Mount)
● Ultrasonic coupling compound
● Sensors (matched set)
32
FUH1010 IP65 NEMA 7 Interface Detector Quick Start
Operating Instructions, 06/2014, A5E02428148-AA