Maintaining The Pneumatic Tool; Accessories - Bostitch HP118K Manuel D'instructions Et D'entretien

Pistolet à goupilles sans tête calibre 23

Masquer les pouces

Table des Matières

Les langues disponibles

When working on air tools, note the warnings in this manual and use extra care evaluating

problem tools.

REPLACEMENT PARTS:

BOSTITCH replacement parts are recommended. Do not use modified parts or parts which will not give

equivalent performance to the original equipment.

ASSEMBLY PROCEDURE FOR SEALS:

When repairing a tool, make sure the internal parts are clean and lubricated. Use Parker "O"-LUBE or

equivalent on all "O"-rings. Coat each "O"-ring with "O"-LUBE before assembling. Use a small amount of oil

on all moving surfaces and pivots. After reassembly add a few drops of BOSTITCH Air Tool Lubricant

through the air line fitting before testing.

AIR SUPPLY-PRESSURE AND VOLUME:

Air volume is as important as air pressure. The air volume supplied to the tool may be inadequate because of

undersize fittings and hoses, or from the effects of dirt and water in the system. Restricted air flow will

prevent the tool from receiving an adequate volume of air, even though the pressure reading is high. The

results will be slow operation, misfeeds or reduced driving power. Before evaluating tool problems for these

symptoms, trace the air supply from the tool to the supply source for restrictive connectors, swivel fittings,

low points containing water and anything else that would prevent full volume flow of air to the tool.

TRIGGER VALVE REMOVAL:

1. Remove the two trigger valve pins as well as the secondary trigger and it's spring.

2. Remove the trigger valve (with primary trigger still attached to it).

Trigger

valve pin

Trigger valve and

primary trigger

BC601

BC602

BC603

BC604

100679

851325

851385