Power Adjustment Valve - Bostitch HP118K Manuel D'instructions Et D'entretien

FASTENER JAM CLEARING
ALWAYS DISCONNECT AIR SUPPLY BEFORE CLEARING A JAMMED FASTENER.
TO CLEAR A JAMMED FASTENER:
1. Release the magazine and pull it back to stop pin feeding.
2. Loosen the two screws as shown in Fig.1 by one full turn.
3. Slide cover down until the two large clearance holes line up with the two screw heads as shown in Fig.2.
4. Pull the cover away from nose as shown in Fig.3.
5. Remove the jammed fastener.
6. Re-install cover, slide it up, tighten the two screws and close magazine.
7. Reconnect air hose.
POWER ADJUSTMENT
For maximum power: rotate lever to right as shown in Fig.1
To reduce power: rotate lever to left as shown in Fig.2
MAXIMUM POWER SETTING
Fig.1
Fig.1
-10-
Fig.2
MINIMUM POWER SETTING
Fig.3
Fig.2