Loading The Tool - Bostitch MFN-201 Manuel D'instructions Et D'entretien

EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when loading, operating or servicing this tool. Eye protection is
required to guard against flying fasteners and debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded spectacles
and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Always handle the tool with care.
• Do not contact the actuator while loading the tool.

LOADING THE TOOL

1. Release the pusher spring clip and remove the pusher blade.
2. Load the fasteners into guide channel.
3. Insert rounded end of pusher blade into channel to retain fasteners.
4. Latch pusher spring clip to notched end of pusher blade. Ensure sufficient engagement of pusher blade for
smooth fastener feeding.
FASTENER MAY NOT FEED CONSISTENTLY IF PUSHER BLADE IS NOT INSTALLED.
BEFORE HANDLING OR OPERATING THIS TOOL READ AND UNDERSTAND THE WARNINGS
CONTAINED IN THIS MANUAL.
All manuals and user guides at all-guides.com
1.
3.
5
LOADING THE MFN-201
2.
4..