Bosch GSR 36 V-LI Professional Notice Originale page 11

OBJ_BUCH-503-001.book Page 11 Wednesday, September 26, 2007 12:44 PM
Turn the bottom part of the auxiliary handle 7 in
counterclockwise direction and swivel the auxil-
iary handle 7 to the desired position. Then re-
tighten the bottom part of the auxiliary handle 7
by turning in clockwise direction.
The clamping band 14 of the auxiliary handle
must be seated in the corresponding groove.
Changing the Tool (see figure C)
Before any work on the power tool (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the center posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
The drill spindle is locked when the On/Off
switch 6 is not pressed. This makes quick, conve-
nient and easy changing of the tool in the drill
chuck possible.
Open the keyless chuck 1 by turning in rotation
direction until the tool can be inserted. Insert
the tool.
Firmly tighten the collar of the keyless chuck 1 by
hand in rotation direction
tion ("click") is no longer heard. This automati-
cally locks the chuck.
The locking is released again to remove the tool
when the collar is turned in the opposite direc-
tion.
Replacing the Drill Chuck
Before any work on the power tool (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the center posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
Removing the Securing Screw (see figure D)
The keyless chuck 1 is secured with a securing
screw 16 against unintentional loosening from
the drill spindle. Completely open the keyless
chuck 1 and unscrew the securing screw 16 in ro-
tation direction . Please note that the securing
screw has a left-hand thread.
Bosch Power Tools
Removing the Drill Chuck (see figure E)
Clamp the short end of a hex key 17 into the key-
less chuck 1.
Place the machine on a stable surface (e.g. a
workbench). Hold the machine firmly and loosen
the keyless chuck 1 by turning the hex key 17 in
rotation direction
less chuck by giving the long end of the hex key
17 a light blow. Remove the hex key from the key-
less chuck and completely unscrew the keyless
chuck.
Mounting the Drill Chuck (see figure F)
The keyless chuck is mounted in reverse order.
Note: After mounting the keyless chuck, screw
the securing screw 16 back in again.
Operation
Starting Operation
until the locking ac-
Inserting the Battery
Set the rotational direction switch 5 to the center
position to protect the power tool against acci-
dental starting.
Insert the charged battery 8 from the front into
the base of the power tool. Push the battery com-
pletely into the base until the red stripe can no
longer be seen and the battery is securely locked.
Reversing the Rotational Direction
(see figure G)
The rotational direction switch 5 is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch 6 actuated.
Right Rotation: For drilling and driving in screws,
push the rotational direction switch 5 left to the
stop.
. Loosen a tight-seated key-
The drill chuck must be tightened with a
tightening torque of approx. 10–25 Nm.
Use only original Bosch lithium ion batteries
with the voltage listed on the nameplate of
your power tool. Using other batteries can
lead to injuries and pose a fire hazard.
1 609 929 M42 | (26.9.07)
English | 11