Altrad TRON-045-T45 Manuel D'instructions Et D'utilisation page 32

10. Maintenance
---------------------------------------------------------------------------------------------------------------
WARNING

Be sure to round off the front edge to reduce
the chance of kickback or tie-strap breakage.
Make sure every cutter has the same length and edge
angles as illustrated.
Cutter length
11. Troubleshooting Guide
---------------------------------------------------------------------------------------------------------------
Case 1. Starting failure
WARNING

Make sure the icing prevention system is not
working.
Check fuel for water or
substandard mixture.
Check for engine
flooding.
Check spark ignition.
Case 2. Lack of power / Poor acceleration /
Rough idling
Filing angle
Side plate angle
Top plate cutting angle
Replace with proper
Remove and dry the
spark plug.
Then pull the starter
again with no choke.
Check fuel for water
or substandard
mixture.
■ Guide Bar

Reverse the bar occasionally to prevent partial
wear.

The bar rail should always be square. Check for
wear of the bar rail. Apply a ruler to the bar and
the outside of a cutter. If a gap is observed
between them, the rail is normal. Otherwise,
the bar rail is worn. Such a bar needs to be
corrected or replaced.
Ruler
Gap
No gap
Check fuel for water or
substandard mixture.
Check air filter and fuel
filter for clogging.
Check carburetor for
inadequate adjustment.
Case 3. Oil does not come out
Check oil for
substandard quality.
Check oil passage and
ports for clogging.
If the unit seems to need further service, please
consult with an authorized service shop in your area.
GB
Replace with proper
fuel.
Clean.
Readjust speed
needles.
Replace.
Clean.